Instructions

STOPCOR Heater PRO 1 & 2 instructions

STEP ONE:

Fit the STOPCOR® device inside the supplied mounting bracket and using the provided screws, securely fix it on a stable point on the wall near the water heater/equipment under protection.

STEP TWO:

Connect the red cable on the upper side of the device (having exposed the copper wiring inside the cable) on a clean metal point of the pipe on the equipment using the metal cable clamp provided, ensuring electrical conductivity.

STEP THREE:

Using drilling tools, carefully drill a hole on the wall/plasterboard until the brick wall behind it is reached. This is meant to be the grounding point where the wedging anchor is secured. Connect the yellow/green cable attaching one end to the terminal pin on the STOPCOR® device and the other end to the wedging anchor on the wall, ensuring electrical conductivity.

STEP FOUR:
Activate the device by adding 5ml for Heater Pro 1 – 10ml for heater Pro 2 of tap water with the syringe into the hole on the top of the device.