Commercial line

STOPCOR COMMERCIAL LINE

Electrochemical Corrosion Prevention and Limescale Reducer.

The innate complexity of large scale commercial piping networks represents an entirely different challenge for the engineers.

Electrochemical corrosion causes damage to metal structures, plumping installations, heating boilers, gas equipment, tanks etc.

The answer lies in utilizing the unique STOPCOR® C5, C7, C9 patented technology while maximizing the protective potential of the anode.

The STOPCOR® Commercial Line meets the varying demands of commercial facilities.

STOPCOR® is a self-contained device which provides cathodic protection through a sacrificial magnesium anode, without the need of an external power source.

It imposes current up to 1.5 V which covers and protects wide metal surfaces with much less sacrificed mass of active metal (anode).

The protected surface remains negatively charged but its action is reversed and is now inclined to undergo reduction instead of oxidation.

The impressed current must be over 1 volt but it must not exceed 10mA.

Installation for commercial product line


Installation Instructions
STEP ONE:

Fit the STOPCOR® device inside the supplied mounting bracket and using the provided screws, securely fix it on a stable point on the wall near the equipment under protection.

STEP TWO:

Connect the black cable on the upper side of the device (having exposed the copper wiring inside the cable) on a clean metal point on the equipment using the jubilee clip provided, ensuring electrical conductivity.

STEP THREE:

Using drilling tools, carefully drill a hole on the wall. This is meant to be the earthing point where the wedging anchor is secured. Connect the yellow/green cable attaching one end to the terminal pin on the STOPCOR® device and the other end to the wedging anchor on the wall, ensuring electrical conductivity.

STEP FOUR:
Activate the device by adding 20ml for C5 – 30ml for C7 – 50ml for C9 of tap water with the syringe into the hole on the top of the device.

Benefits

  • Self-contained device
  • No external power source required.
  • No contact with water or liquids.
  • Reduction of limescale and sludge.
  • Consistent voltage and amperage.
  • 3 years of protection.
  • No intervention in the installations.
  • Protection of extended surfaces.
  • Environmentally friendly

Other available methods such as corrosion inhibitors, magnets, etc. only serve as a way of slowing down the process of corrosion instead of stopping it altogether and that is what STOPCOR provides.

  • Large scale plumping installations
  • Commercial heating boilers
  • Commercial gas equipment
  • Cylinders
  • Water pipes
  • Circulators
  • Pumps
  • Tanks

Selection Guide

Type Heating boiler Cylinder or Tank Sqft covered
STOPCOR C5 80 KW + 500lt 2000
STOPCOR C7 100 KW + 1000lt 3500
STOPCOR C9 280 KW + 2000lt 5000